Precision cut. Zero guesswork.
Every panel, matched.
Ultraguard's Precision Pre-Cut PPF is shaped to the millimetre for Indian car interiors. Follow this sequence exactly and you'll get a factory-finish result with no trimming, no blades near the dash, and no guesswork on which piece goes where.
What you'll need
- Ultraguard Interior Pre-Cut PPF Kit
- Fresh microfiber towel
- Isopropyl Alcohol (IPA)
- Baby shampoo 3 drops
- Spray bottle 400ml water
- Soft-edge squeegee
- Precision Cutter release tabs only, never for trimming
Step-by-step installation
Wipe the surface using IPA and a clean microfiber towel. Remove all dirt, fingerprints, and oils from panels like infotainment screens, piano black trims, and gear surrounds.
Use an ideal cutter or blade to gently release the pre-cut pieces from the sheet if held by micro tabs. Never use a cutter on the car's surface — it's only for lifting film pieces.
Scan the QR code on your kit to understand the layout and know which piece goes where. Match each film precisely to its corresponding interior part before touching adhesive.
Clean the selected surface again with IPA before applying the film, so it's completely free from residue and fully dry.
Mix 3 drops of baby shampoo into 400ml of water in the spray bottle. This slip solution gives you time to reposition the film before it sets.
Spray the slip solution on the adhesive side of the film — never directly on the interior surface — then place the film on the panel and adjust as needed.
Use a soft-edge squeegee to push out excess water and air bubbles from the centre outwards. Take your time — the surface should end up smooth and bubble-free.
Don'ts — what to avoid
Always spray only on the film to avoid moisture damage to electronics or trims.
Ultraguard Pre-Cut PPF is precision-cut to fit perfectly — blades can damage your car's interior.
- Work in a clean, dust-free space.
- Avoid touching the adhesive side of the film.
- Let the film set for 24 hours before cleaning or applying strong pressure.